[urq] Megaquirt V2.2 5 cyl configuration

[QSHIPQ at aol.com]

Ben
Ck TDC again and do it the manual method
 
Pull the valve cover off, put #1 cam lobe in the correct position, and make  
sure the distributor is also at TDC.  Then pull number 1 plug out of the  hole 
and drop a screwdriver or a zip tie down the hole and roll up to TDC.
 
I got a dollar your cam/crank timing is off, whatever your marks say.   The 
first indication of spark and no start with starting fluid is you're blowing  
it thru open valves.
 
Scott J
In a message dated 4/26/2007 7:37:26 A.M. Central Standard Time,  
benswann at comcast.net writes:

OK - I  changed the wires around - tried 180 out as well as one terminal
clockwise  and one terminal counter.  All these changes resulted in  slower
cranking.  The best cranking speed is when set with #1 wire  over cap terminal
position above the hash mark where I originally had  it.  Compared with 
another
single window UrQ and the wires are in the  same position.  I am sure I have
this correct.

Still no fire  using ether.  My best guess is it is flooded and plugs may now
be  fouled.

Fresh motor - new rings and bearings, but turns freely. Good  spark.  I think
it is trying to come to life.

Keep those ideas  coming.

Ben







************************************** See what's free at http://www.aol.com.