[urq] Ignition switch?

[Charles Baer]

I had to drill a hole in the housing on my 200s, the red factory book 
shows the same procedure.

The photo in the manual shows the housing looking down from the top at 
the V between the column and the key cylinder housing.  The photo shows 
a rib along the length of the cylinder body above the part number, in 
this case "171905851".

The description says to use a 3mm bit to drill 12mm from the opening end 
  of the housing and 10mm above the ridge.


Hope that does it, you'll be needing a steering column tomorrow...


DGraber460 at aol.com wrote:
> I am truing to replace my ignition switch on the early build 83 URQ, and  not 
> having much luck.
> I have the entire steering column on the bench and there is no access to  the 
> retaining screw. It is all TOTALLY encapsulated in cast aluminum.
> I have done this on my later build car and don't remember this at  all.
> Any BTDT appreciated. 
>  
> Dennis
> Denver
> 
> 
> 
> ************************************** AOL now offers free email to everyone. 
>  Find out more about what's free from AOL at http://www.aol.com.
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> Have an urq question?  Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/UrQuattro
> Have an urq answer? ... Please help others by adding to the KB ... all contributions welcome!