[urq] In Tank Screen Removal

[Ben Swann]

Well, I do have the tank drained already.  Yes the hose(s) at the bottom are  curved and
a trick to get to.

 

I figured it might be best to pull the tank, but of course was hoping there would be an
easier way.  Just don't want this to come back and haunt me.  So looks like I have
today's work cutout.  If I end up pulling the tank, I'll be sure to let folks know how
difficult it is.  Doesn't seem to be that bad as long as the hoses come off easily.  I
will try getting through the sender hole first.

 

I already have the pre-filter in hand.  I got one that you can see through clearly,
although the inlets are not as big as the OEM Bosch one made of clear plastic - but you
could barely see through that.  Interesting that the OEM pre-filter has larger barb
fittings than anything else I could find on the shelf.

 

Any other ideas?

 

Ben

 

  _____  

From: mike schowengerdt [mailto:urdrquattro at yahoo.com] 
Sent: Tuesday, October 16, 2007 11:42 PM
To: Ben Swann
Subject: Re: [urq] In Tank Screen Removal

 

Ben,  I am one who suggested that could be a problem.  I think the 'correct' way to deal
with this would be to remove the tank and then the fuel gauge sender to access it.
Having said that and considering how much work that would be, I think if there is
straight access through the outlet from the bottom, poking large holes in the screen
that way would yeild the same net cure. If it is a curved outlet pipe (I don't know or
remember), then you might accomplish the same thing using a piece of clutch or handbrake
cable driven by a slow speed screwgun/drill.

Installing a good  pre-pump filter after this abortion would be requisit, IMHO.

 

mike w/ 84 4kqt Em , needing same surgeries

         w/ 83 urQ, probably needing same , if 3B ever gets installed

----- Original Message ----
From: Ben Swann <benswann at comcast.net>
To: Ben Swann <benswann at comcast.net>; urq list <urq at audifans.com>
Sent: Tuesday, October 16, 2007 9:07:45 PM
Subject: Re: [urq] In Tank Screen Removal

I?m finally getting to do the fuel pump repairs.  How do I remove the screen in the
tank?

I got a lot of suggestions to check this a week or so ago.  In fact I?d like to remove
it.  Thought I had already eliminated anything to slow the flow but this can only cause
trouble.  How do I get it out or make it so all I have is a clear line into the tank?
Can I just poke it out?

Ben