[urq] Oil Pressure Sender Location
Keith Lloyd
spotatashleys at hotmail.com
Tue Mar 30 11:51:53 PDT 2010
Maurits
The second sender can indeed go where the allen head plug is located. Both
drillings are in to the same oil gallery.
Regards
Keith
----- Original Message -----
From: "Maurits Jonkergouw" <urquattro at moregraphics.nl>
To: "Audifans" <urq at audifans.com>
Sent: Monday, March 29, 2010 11:15 PM
Subject: [urq] Oil Pressure Sender Location
> Please take a look at this picture and tell me where the oil presure
> sender(s) should go. Currently the empty hole (just below the brass alan
> key plug) has the large 2-pin gauge with just one wire attached to
> terminal "G".
>
> http://www.moregraphics.nl/quattro/images/sender.jpg
>
> The temperature sender in the nose of the oil pump is located (and works
> fine), but where does that second pressure sender go were Tony talks
> about?, in the plugged hole perhaps?
>
> Thanks again.
>
> Maurits,
>
> Since 1985 Audi has used a 2 switch system with a oil pressure warning
> relay (p/n 433919082). The large 2 pin sensor is one of these switches
> (1.8 bar). The pins are marked "G" and "WK" The G terminal runs the oil
> pressure gauge. The WK terminal is the 1.8 bar pressure switch. If you
> remove the sensor, you'll see the pressure spec marked on the base just
> above the threads. There is also a standard 0.3 bar switch (black) that
> is also mounted on the same side of the engine block. There two are
> connected to the relay which buzzes and lights the oil light if it senses
> something wrong.
>
> There is a second type of 2 pin sensor which is a gauge and 0.3 bar
> switch but is used only on 1981 4000 and coupe GT cars.
>
> HTH,
>
> Tony
> _______________________________________________
> Audifans urq mailing list
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
> http://www.audifans.com/kb/List_information
>
> Pictures/Polls/Database at: http://autos.groups.yahoo.com/group/urquattro/
>
>
More information about the urq
mailing list