[urq] Flywheel and clutch

[Jack Walker]

So is there a specific thickness you're looking for on the flywheel clutch
surface to the rear of the flywheel? Or another measurement??

I've got a Fizanza flywheel and I was watching this with interest seeing as
this will all be bolted to a 016 trans very soon!

 

Jack

 

  From: qshipq at aol.com 

  To: brogers at terrix.com ; ejfluhr at austin.rr.com ; urq at audifans.com 

  Sent: Wednesday, February 23, 2011 11:01 AM

  Subject: Re: [urq] Clutch for 20vt install?

 

 

  Eric

  The answer is "it depends".  I was the first shop to actually try to fit
the Fidanza Flywheel to a tq016 many years ago (late 90's).  The early
Fidanza flywheels were not correctly machined for the 20vt motors.
Basically the depth of the flywheel was around 6-7mm too deep IIRC, which
caused the clutch to not be able to fully engage.  I ended up making a jig
on a press and determined that the thickness dimension of the FW was
incorrect.  I might have the notes I made on was was required to make it
fit.  Also found out at the time BTW, that on this particular early FW -
Fidanza put the timing pin in the correct location, but it was an aluminum
pin not steel.   

 

  Otherwise, you can use the 91 200tq FW and Clutch with an AAN/016 as a
bolt-on.  

 

  HTH

 

  Scott J