[urq] RE AAN/3B Swap

[Martin Pajak]

Just to add, 

Use the V8 output flanges as well, not just the internals, 4kq is 100mm and
will not fit the Ur-q shafts.
And get the V8 "big" flange seal, its different from the 4kq one.

HTH
Martin Pajak

http://www.quattro.ca 

1981 VW Scirocco, all original
1982 Audi Ur-quattro, SQ project
1983 Audi 80 quattro, Euro 2-Tür
1993 Audi 90 CS quattro, 2.5 TDI with 6-speed
1993 Audi 80 quattro Avant, 2.5 TDI with 6-speed
1994 Audi S2 Avant, stock


-----Original Message-----
From: urq-bounces at audifans.com [mailto:urq-bounces at audifans.com] On Behalf
Of Steve
Sent: 6-Feb-14 09:10
To: urq at audifans.com
Cc: Tom Bylaitis
Subject: [urq] RE AAN/3B Swap


Regarding the 4:11 setup
The stock driveshaft is used
The 4k rear case will accept the v8 internals but should be adjusted
(shimmed) professionally .
The outer case is plug 'n play
When  you go shopping for a v8 rear diff just have the internals shipped to
you Saves shipping costs & the case is just a boat anchor anyway It wouldn't
hurt to balance your driveshaft Good luck Steve Sent from my iPhone
_______________________________________________
Audifans urq mailing list
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
http://www.audifans.com/kb/List_information

Pictures/Polls/Database at: http://autos.groups.yahoo.com/group/urquattro/



-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3462 / Virus Database: 3684/7067 - Release Date: 02/06/14

-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3462 / Virus Database: 3684/7066 - Release Date: 02/05/14