[V6-12v] replacing ignition coil packs

[James4ihl at aol.com]

I'm pretty sure those wires must go to the ignition output stage which is in 
the middle of the baulkhead at the back of the engine bay. You'll see several 
electrical connections there: a group of 5 plugs for various sensors on the 
left (this is looking at the engine bay from the front) with a connector for 
lambda probe 1 behind them, then in the middle you'll see a brown coloured 
connector with two longer plugs in them. On the left side is a brown 4-way connector 
which comes from the ECU and on the right side is a 3 way connector which 
directly feeds the ignition coils - running underneath the intake manifold, 
presumably...

In a message dated 26/6/04 12:49:40 am, kentmclean at mindspring.com writes:


> I'm trying to replace the ignition coil pack on my
> new-to-me '94 100 S Avant.  The old pack unbolted
> real easy (3 6mm hex-head bolts). But before I could
> pull it out, I have to undo two electrical connectors.
> That stopped me dead in my tracks.  The wires go into
> the engine under the intake manifold.  I can't tell
> where they come out, or where they connect to.
> 
> Can anyone tell me how these wires are routed, and
> where to look for the end so I can disconnect it?
> 
> Thanks,
> Kent