[V6-12v] CAts -- project stopped ...
Clive Young
cyoung1661 at rogers.com
Sun May 20 11:43:57 EDT 2007
Well I got the fender washers for the new cat as te nuts would have been too small but the project has now stopped... I am still about 1-1.5 cm short with the new cat , The rear exhaust system has both sides welded together and the other side is of course fastened to that ca and the exhaust manifold. It is impossible to take up the gap on this side . If I try I am sure it will just snap the studs off the exhaust manifold as something has to give.. any one have any ideas other than returning that cats which is just NOT an option..
Tom how were you able to make up the difference ?
More information about the V6-12v
mailing list