[V8] CV Joint Removal?!

[Jeff Goldberg]

I used a slide hammer bearing puller with the jaws turned
inward and attached it to the shoulders of the "new style"
bolt.  A couple of good taps and it popped right off.

Jeff

> -----Original Message-----
> From: v8-bounces at audifans.com
> [mailto:v8-bounces at audifans.com]On Behalf
> Of CoultL at aol.com
> Sent: Thursday, December 11, 2003 3:24 PM
> To: v8 at audifans.com
> Subject: [V8] CV Joint Removal?!
>
>
> I got my boot kits in the mail and started to
> disassemble the joints.  I cant
> seem to get the outer joint apart.  From what I
> have gathered I need to
> thread the new axle bolt in until it contacts the
> end of the axle shaft.  I then
> torque it and the shaft should pop off.  I put a
> lot of torque into this bolt
> and nothing popped off.  I want to make sure this
> method is correct before I use
> a bigger breaker bar.  Any BTDTs.  Thanks in advance.
>
> -Justin Lewis
> _______________________________________________
> V8 mailing list
> V8 at audifans.com
> http://www.audifans.com/mailman/listinfo/v8