[V8] Knock Sensor Wire Insulation

[Korn, Bob]

I have wrapped mine with electrical tape in the areas where the insulation
has become brittle and broken away.  This has worked well.
Bob

-----Original Message-----
From: Jeff Goldberg [mailto:jgoldberg at ntelos.net] 
Sent: Friday, November 21, 2003 7:14 AM
To: @V8 list; Carol, Dave, and Zach Weiss
Subject: RE: [V8] Knock Sensor Wire Insulation


I coated over the shield in several places with black RTV silicone.

Jeff

> -----Original Message-----
> From: v8-bounces at audifans.com [mailto:v8-bounces at audifans.com]On 
> Behalf Of Carol, Dave, and Zach Weiss
> Sent: Thursday, November 20, 2003 10:12 PM
> To: v8 at audifans.com
> Subject: [V8] Knock Sensor Wire Insulation
>
>
> Glad the list is back up!
>
> The left knock sensor (on the outside of the
> block, brown connector on
> the IM) wire insulation is in bad shape-can see
> the shield in several
> places.  The insulation doesn't look like the one
> on the other side,
> either.  This on looks like it is a wrap, as
> opposed to a smooth jacket
> on the right side.  Engine runs fine.
>
> Question-can I wrap this w/ electrical tape
> (maybe spiral poly-Et= on
> top), or is the heat too much?  If no, what
> should I use, or just
> replace it?
>
> Dave Weiss
> V8 5-speed
> _______________________________________________
> V8 mailing list
> V8 at audifans.com
> http://www.audifans.com/mailman/listinfo/v8

_______________________________________________
V8 mailing list
V8 at audifans.com
http://www.audifans.com/mailman/listinfo/v8