[V8] upper radiator hose

[Kneale Brownson]

When I epoxied a bit of copper pipe in place of the broken neck on my
200q20v's plastic radiator,  I soldered a piece of solid copper ground wire
from some Romex around the outer end of the pipe to be the "barb".   Didn't
look wonderful, but who's going to see it inside the hose?

At 02:10 PM 8/2/2004 -0500, Hoffman Anthony J A1C 552 CMS/MXMVC wrote:
>I have the parts one to work from, and I've seen coppe reducers for home
>plumming, just a matter of finding the right sizes. About the ends, If it is
>possible to find a double flare tool that large, you could use it.
>Otherwise, I'll have to figure something else out. I was thinking about
>building up a ridge with solder, but I also want it to look decent.