[V8] Eastern MA UFO machining

[Jeremy Ward]

Brett,

Is this your UFO?
http://www.audiv8.com/forum/avatars/2314_big.jpg 

I know there was a special jig built to turn the UFOs, but don't
remember the details...  Maurice might have the contact info...

- Jeremy

-----Original Message-----
From: v8-bounces at audifans.com [mailto:v8-bounces at audifans.com] On Behalf
Of Brett Dikeman
Sent: Tuesday, August 17, 2004 9:00 PM
To: 200q20v at audifans.com; v8 at audifans.com
Subject: [V8] Eastern MA UFO machining

My front UFO rotors have glazing, rust, etc beyond what I can "fix" 
with sandpaper, and of course I can't very well get to the inside to 
pound/sand off the glaze(I've removed almost all of it from the 
outside).  They're practically brand new, so they should have plenty 
of meat left on them.

Have any listers in my area(eastern MA) found a shop which can 
machine UFO rotors?  I do recall a special lathe is required to get 
the cutting tool into position for the inside surface and clear the 
shell.

If not, what's the closest shop?  Obviously on something this heavy 
cross-country is not preferable.

Thanks,
Brett
-- 
"They that give up essential liberty to obtain temporary
safety deserve neither liberty nor safety." - Ben Franklin
http://www.users.cloud9.net/~brett/
_______________________________________________
Audifans V8 mailing list
Send posts to: mailto:V8 at audifans.com
Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
Have an Audi V8 question?  Check the Audifans Knowledgebase!
http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/V8
Have a V8 answer? ... Please help others by adding to the KB ... all
contributions welcome!