[V8] V8 engine swap into 200TQ

[DasWolfen at aol.com]

In a message dated 1/14/04 6:53:24 PM Eastern Standard Time, conrads at wwdb.org 
writes:

> I'm thinking about swapping a 3.6 into a 200TQ.  While I can handle the 
> wiring/plumbing challenges, I'm not sure about matching up bellhousings, 
> clutches, timing sensors, etc.  Any ideas on what might work?  Will it bolt up to 
> the existing trans, etc?  Thanks!!

I'm doing the same conversion right now on an 89 200q

 Bellhousing is fine
Flywheel...use the V8 part
Clutch use the 200 part for the late 89-91

Timing sensors are a non issue.

 A bunch of mounts need to be moved around. You need the short V8 brake 
booster.

 I havent looked much further yet.

KT