[V8] bulb failure lamp on dash

[DasWolfen at aol.com]

In a message dated 3/6/04 9:22:38 AM Eastern Standard Time, 
kyle_leatherwood at hotmail.com writes:

> made a relay harness for my V8 yesterday.  It works flawlessly except for 
> when I cut on the low beams the bulb failure lamp comes on in the data 
> center in the center of the dash.  Strangely enough, it only does it on low 
> beam.  If I switch to high beams it goes off.  Has anyone else experienced 
> this problem and if so how is it fixed.  I can't take the beeping and lamp 
> coming on every time I change to low beams, but if I have to I will jerk off 
> 
> the relay harnesses and just have to burn up switches.

 Nothing that should have been a surprise since this subject has only been 
covered about 2 bazillion times.

 Only the low beams are monitored.

 Remove Bulb monitor from passengers footwell, bend pin "K" 90 degrees and 
reinstall. This removes the failure signal to the cluster.