[V8] Help!! It still doesn't run! WTF Update

[bob moy]

No you can not place the distributor 180D off,  but yes you can place the 
rotor 180D off if you are not careful (BTDT).

Try disconnecting the hall sensor to the right distributor and see if it 
starts.  The engine can start without the hall sensor plugged int (BTDT).


[V8] Help!! It still doesn't run! WTF Update
Tony and Lillie tonyandlillie1 at earthlink.net
Thu Nov 4 19:34:27 EST 2004

Previous message: [V8] @$#%#@# Audis are telepathic
Next message: [V8] Help!! It still doesn't run! WTF Update
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

--------------------------------------------------------------------------------

Ok, I sure hope someone can help. I'm no V8Q expert, and this car seems as 
if it's out to show me just how true that is.
We swapped both reference sensors out of the 5k to no avail. We also swapped 
ECU's, still no run. Nothing, just acts like it wants to start, then floods 
out in a matter of 5 seconds. Pulled codes today. We got the folowing:
1.    2322 (inlet air temp) - slight power loss, increase in fuel 
consumption.
2.    2113 (hall sender in distributor) - mis-located sensor and 
distributor.
3.    2121 (idle switch) - switch defective - this could be due to me 
pushing on the pedal while cranking.

First, is it possible to put the distributor in 180degrees out? by the 
looks, it doesn't seem possible.
Can anyone else help?

Tony Hoffman


Swimming in about 8 Audi's too many :-(


--------------------------------------------------------------------------------


Previous message: [V8] @$#%#@# Audis are telepathic
Next message: [V8] Help!! It still doesn't run! WTF Update
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

--------------------------------------------------------------------------------
More information about the V8 mailing list