[V8] Leather seat repair

[dsaad at icehouse.net]

This from Carlson Audi:

Seat bottom cushion available - Audifans list price is $118.
Seat back cushion is available - $135
Seat bottom Leather is NLA but full retail price is: (GULP) $871
I did not bother to price the seat back leather but oddly it is still available.

So - at the moment, it looks like $300 for a top notch rebuild of my entire seat
by a local craftsman who happens to specialize in German Iron - err I mean
Leather is the most cost effective route - other than a nice "Indian Blanket"
that is.

(unless of course someone has a good seat they swapped out or something equally
unlikely)

Dave


Quoting "Buchholz, Steven" <Steven.Buchholz at kla-tencor.com>:

> ... I don't have BTDT on the "comfort" (AKA Barcolounger) seats, but I
> know that on the sport seats (i.e. the one with 3 separate sections in
> the seat bottom ... middle w/2 bolsters) the foam pieces are still
> available from Audi, and the price is not terrible.  On those seats, IME
> the problem is that the metal frame breaks through the reinforcement in
> the pad ... I wrap closed cell foam around the metal to try to spread
> the load over more of the reinforcement ... so far, so good ...
>
> Steve B
> San Jose, CA (USA)
> >
> > Another possibility is to find a passenger side bottom and
> > side, and cut the
> > leather from it to use on your seat. I've done this for years
> > with the foam
> > in the 4000Q/GTI seats. You might try to do the same with the
> > foam on the
> > bottom. For that matter, I'd use the whole bottom. The center
> > where you sit
> > probably hasn't had much traffic. Therefore it should have
> > better support.
> _______________________________________________
> Audifans V8 mailing list
> Send posts to: mailto:V8 at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
> Have an Audi V8 question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/V8
> Have a V8 answer? ... Please help others by adding to the KB ... all
> contributions welcome!
>