[V8] Fault code 2341

[Daniel Hussey]

This may be a silly question, but are there one or two O2 sensors on a V8
Quattro?

Later,
Dan

----- Original Message -----
From: "Enzeder" <enzeder at comcast.net>
To: <V8 at audifans.com>
Sent: Saturday, April 16, 2005 6:36 AM
Subject: Re: [V8] Fault code 2341


> Riiiight...
>
> I ordered a "factory" replacement O2 sensor so I didn't have to mess with
> splicing, and it appeared to be "generic" in the sense that the connector
> was correct, but the length was wrong.  I had to add a service loop about
> 6" in diameter, so it was no where near the right length.  Considering the
> proximity to the left exhaust, I had to be careful with the placement of
> the loop
>
>
> At 12:58 AM 4/16/2005, Coleman, David wrote:
> >With all the talk of non-OE O2 sensors, and just to xpound on Keith's
> >post, recall the proper O2 replacement, whatever the original application
> >intended, is to keep the cable/wires near as possible to the factory
length.
> >
> >FWIW,
> >Davec
> >
>
> _______________________________________________
> Audifans V8 mailing list
> Send posts to: mailto:V8 at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
> Have an Audi V8 question?  Check the Audifans Knowledgebase!
> http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/V8
> Have a V8 answer? ... Please help others by adding to the KB ... all
contributions welcome!