[V8] Fault code 2341

[Enzeder]

Riiiight...

I ordered a "factory" replacement O2 sensor so I didn't have to mess with 
splicing, and it appeared to be "generic" in the sense that the connector 
was correct, but the length was wrong.  I had to add a service loop about 
6" in diameter, so it was no where near the right length.  Considering the 
proximity to the left exhaust, I had to be careful with the placement of 
the loop


At 12:58 AM 4/16/2005, Coleman, David wrote:
>With all the talk of non-OE O2 sensors, and just to xpound on Keith's 
>post, recall the proper O2 replacement, whatever the original application 
>intended, is to keep the cable/wires near as possible to the factory length.
>
>FWIW,
>Davec
>