[V8] Got to visit with Zay and Tony in Vegas

[Greg Furstenwerth]

yeah this is no fun to get to :/ Is it possible to use a wrench or will 
that cause problems cause as I see it a wrench is the only way I am 
going to get it out otherwise I have to take a buncha crap apart I will 
look again when I take the picture for you guys but hey...

Kneale Brownson wrote:

>Ahhhh, my experience was with a '90 V8, where the "Y" in the piping that
>contains the sensor is marginally available.
>
>
>At 06:58 PM 12/5/2005 -0800, Greg Furstenwerth wrote:
>  
>
>>Now I am having all kinda problem sorry if this doubleposts
>>
>>What I am wondering is where it is located how to get the socket or 
>>whatever up there without having to remove anything... it is being 
>>blocked by part of the subframe on the 93 v8...
>>
>>
>>
>>Kneale Brownson wrote:
>>
>>    
>>
>>>I cut the wire at the sensor and put a long socket over it.  Used a breaker
>>>bar and piece of pipe as an extension.  They make a special socket with a
>>>slot in it for the wire, but the amount of trouble I had (part of the
>>>threads from the sensor remained in the bung) probably would have led to
>>>the socket failing.  I had to run a tap through the bung several times to
>>>clean it out before installing the replacement sensor.
>>> 
>>>
>>>      
>>>
>>_______________________________________________
>>Audifans V8 mailing list
>>Send posts to: mailto:V8 at audifans.com
>>Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
>>Have an Audi V8 question?  Check the Audifans Knowledgebase!
>>http://www.audifans.com/twiki/bin/view/Audi/V8
>>Have a V8 answer? ... Please help others by adding to the KB ... all 
>>contributions welcome!
>>    
>>
>
>_______________________________________________
>Audifans V8 mailing list
>Send posts to: mailto:V8 at audifans.com
>Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
>Have an Audi V8 question?  Check the Audifans Knowledgebase!
>http://www.audifans.com/twiki/bin/view/Audi/V8
>Have a V8 answer? ... Please help others by adding to the KB ... all contributions welcome!
>
>  
>