[V8] another heater core veteran

[dsaad at icehouse.net]

No - that one is large and necessary. This one is for a 5/16 inch shaft. Like
one of the flaps.
I sort of remember it came from the temp control motor area but I just could not
figure out where. It is a real stumper because I usually am pretty good at this
stuff.

Oh well. If it is necessary it will make itself known to me sooner or later.

Dave

Quoting CoultL at aol.com:

> "The only problem I had was a left over "E" clip with a felt and metal
> washer. I
> remember taking it off - but could not find a place to put it back on.
> Everything seems to work OK however."
>
> That may be from the rear side of the blower motor.  It is held in place by a
> large waster and "E" clip...don't remember the felt though.
>
> -Justin Lewis
>