[V8] RE (10): Brake Sensor

[Campozano, Robert]

Thanks for the heads up...I was going by another lister's post on the
UFO's.  Girling's are *definitely* embedded in the pad though...

Zay Campozano | Computer Engineer | MGM MIRAGE(tm)
rcampozano at MGMMirage.net

-----Original Message-----
From: cobram at juno.com [mailto:cobram at juno.com] 
Sent: Tuesday, January 25, 2005 1:02 PM
To: Campozano, Robert
Cc: v8 at audifans.com
Subject: Re: [V8] RE (10): Brake Sensor

 "Campozano, Robert" <RCAMPOZANO at mgmmirage.net> writes:

> On the Girling equipped V8 it's the same as the UFO's (bare wire
> embedded in the pad).  

Not the same in that the sensor comes imbedded in the non-UFO pads, and
is a separate item in the UFO setup.  
That's why you should never let UFO's go too long after the indictor
light comes on, you'll eat the second sensor wire and some relatively
expensive disks if you go tooo long.  On that note, I've never replaced
both wear sensors on V8Q #2 (UFO's), jumped one side, has never been a
problem because the pads wear very evenly

BCNU,
http://www.geocities.com/cobramsri/