[V8] Sensor Question

[Kneale Brownson]

The sensors are identical except for the color of the plastic cover on the
connector and wiring.  The 077 905 381  Ignition Reference Sender (G4),
which gives the hard hot start symptom when bad, has a black covering,
matching the color of the connector on the other end.  The 077 905 381A
Engine Speed Sensor (G28) has the gray covering.  When I was replacing
them, I could only find the latter, so I installed two of those with black
electrical tape on the one going into the G4 sender location.

At 07:43 PM 6/3/2005 -0600, Jason Carey wrote:
>Audifans,
>
>Help! I have been experiencing what I would describe as 
>the "warm start" problem.  Justs cranks without firing after 
>being driven. Wait 15 minutes and she fires right up.  
>
>So in denial of this I have just been letting it idle when I 
>am stopping for a short period.  However, it just stalled 
>while idleing.  I waited 15 minutes and it fired up but then 
>as I was driving it began to stall.  I would push the 
>accelerator to the floor and it would surge back to life, 
>then begin to stall again.  About five times it surged and 
>then it smoothed out an ran proper.  
>
>Do these sound like the cylinder #1 and speed sensors from 
>June 2 post?  Are there other canidates with similar 
>symptoms?  
>
>Please send correct Sensor Names or Part #'s and any advice 
>(or the fiche #) for the PITA install. 
>
>Thanks,
>Jason
>
>90 V8Q on the brink of 150K. 
>_______________________________________________
>Audifans V8 mailing list
>Send posts to: mailto:V8 at audifans.com
>Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
>Have an Audi V8 question?  Check the Audifans Knowledgebase!
>http://www.audi-quattro.org/cgi-bin/twiki/view/Audi/V8
>Have a V8 answer? ... Please help others by adding to the KB ... all 
>contributions welcome!