[V8] Throttle linkage problem - solved

[DasWolfen at aol.com]

In a message dated 5/17/05 6:50:18 P.M. Eastern Daylight Time,  
radek at istar.ca writes:

I have  not been able to take out the shaft with its bracket but suspect the 
same  or
similar bearing is 
used at the back of the engine as well.   It's very difficult to see given 
very tight
space.  Perhaps  
someone with the engine out of the car could check  that.



The rear of the shaft passes through a small bushing, there is no bearing  at 
all