[V8] Remoting the Headlamp Sensor Module for HeadlightRelayUpgrades

[urq]

I guess if you wanted to have the headlight monitor tell you when a relay 
coil goes bad you'd be right on ... ;-)  All joking aside, that is one way 
to keep the monitor happy in its original location ...

The sensor module has to be in the current path of the lamp filaments for it 
to do its intended job ... and part of the whole reason you're mounting the 
relays under the hood is to eliminate the voltage drop from the factory 
wiring.  That's why the module is being remoted ...

If you wanted to retain the factory location for the module you could mount 
the headlight relays in the car and run new high gauge wire out to the lamps 
... but that seems to be a lot more work than running a single small gauge 
wire back into the cabin ...

Steve B
San Jose, CA (USA)
>
> The relays would then switch the newly installed supply into the
> light control module.  This would allow the light control module
> wiring along with all headlight wiring under the hood to remain
> "stock".
>
> Am I making any sense or am I totally off track?