[V8] V8 No start Part II

[Eric Devansky]

I definateley do not have spark. I tried to check fuel pressure, but I could
not figure out where to check it from, so I pulled the line of the FPR and
it was bone dry in there. Where is a good place to check the fuel pressure?

Thanks!
~Eric


On 11/14/05, dsaad at icehouse.net <dsaad at icehouse.net> wrote:
>
> Remove a pluge wire and see if you have a spark, and verify you have fuel
> pressure. Back to basics....
>
>
> Dave
>
> Quoting Eric Devansky <edevansky at gmail.com>:
>
> > I finally had some time to check out the pin out's on the ECU for the
> > resistance values on my '91 V8Q. From pin 48 - 49 I am getting 982, and
> from
> > pin 47-48 I am getting 974. Both resistance values check out on the
> speed on
> > reference sensors as well.
> >
> > The car cranks, the tach does not bounce, the RPM sensor, and DME relay
> have
> > been replaced.
> >
> > I am afraid now it is going to be the DME, is there any way to bench
> test
> > the DME? What does a new one run?
> >
> > Thanks for the help!
> > ~Eric
> > _______________________________________________
> > Audifans V8 mailing list
> > Send posts to: mailto:V8 at audifans.com
> > Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
> > Have an Audi V8 question? Check the Audifans Knowledgebase!
> > http://www.audifans.com/twiki/bin/view/Audi/V8
> > Have a V8 answer? ... Please help others by adding to the KB ... all
> > contributions welcome!
> >
>
>
>
> _______________________________________________
> Audifans V8 mailing list
> Send posts to: mailto:V8 at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
> Have an Audi V8 question? Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/V8
> Have a V8 answer? ... Please help others by adding to the KB ... all
> contributions welcome!
>