[V8] crank seal/oil pump seal-bearing

[Kneale Brownson]

Here's what sheetrock screws did for removal of my 200q20v's crankshaft
seal:  http://www.pbase.com/kneale_brownson/image/22500169     The tool
that looks like an ice axe did the trick in this case.


At 05:44 PM 10/5/2005 -0400, cobram at juno.com wrote:
>I had a very stuck seal, couldn't get it out with the tool you linked to,
>nor the tool in the manual (borrowed from dealer),  the only way it came
>out was to put 2 sheet rock screws through the old seal, then pull it out
>with a pry bar.  
>
>BCNU,
>http://www.geocities.com/cobramsri/
>On a long enough timeline, the survival rate for everyone drops to zero.
>
>Kneale Brownson <kneale at coslink.net> writes:
>> http://www.thetoolwarehouse.net/shop/LIS-56750.html   
>> 
>> At 12:19 AM 10/5/2005 -0600, John Dodd wrote:
>> >These items seem to require special tools.I have all the seals I 
>> just
>> >don't know if I should bother 
>> >since I 've never done it before and I might screw something up
>> >especially without the tools.
>> >Any BTDT ?