[V8] more tool questions

[cobram@juno.com]

I tighten the bolt as tight as I can with the 2079.  Real technical ;-)

Check out 15-35-2 in the pdf's I emailed.  If you want to use the 2079,
the starred hole at the top of the tool is for inserting a torque wrench,
that's why there are two different values, one for direct to the bolt,
and one for force through the 2079.  

Just make sure the harmonic balancer isn't cocked when you tighten up the
bolt.

BCNU,
http://www.geocities.com/cobramsri/
On a long enough timeline, the survival rate for everyone drops to zero.

John Dodd <john.dodd at sait.ca> writes:
> I'm borrowing some tools so could you please let me know what is 
> needed
> for the crank bolt ?(the one with the big torque)
> I do have the TB tools .
> Do I need a breaker bar 1/2 or 3/4 inch drive ?
> I got a torque wrench that's good to 600 ft-lb but it's a 3/4 
> drive.I do
> have an adapter to 1/2.
> thanks