[V8] crank bolt

[Kneale Brownson]

The 2079 is, in effect, a 27mm socket with a foot or so of lever arm.  The
3/4" triple square hole in the end will accept any sort of 3/4" drive
device.  The factory intent was to use it with a torque wrench for getting
the correct torque on tightening.  The 2079 and a 3/4" drive breaker bar
might be sufficient leverage to undo the bolt.  


At 03:56 PM 10/6/2005 -0600, John Dodd wrote:
>To remove this bolt do you use tool 2079  with a 3/4 " breaker and long
>pipe or a socket ,breaker bar etc ?
>John
> 
>_______________________________________________
>Audifans V8 mailing list
>Send posts to: mailto:V8 at audifans.com
>Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
>Have an Audi V8 question?  Check the Audifans Knowledgebase!
>http://www.audifans.com/twiki/bin/view/Audi/V8
>Have a V8 answer? ... Please help others by adding to the KB ... all 
>contributions welcome!