[V8] various TB questions

[Kneale Brownson]

1.  I used a torx head socket on the end of a 6-inch extension for my 1/4"
drive wrench to BREAK off the head of that screw.  It's a straight shot for
that sort of set-up.

2.   You could use a nail or a punch for 3204.

3.  Dave Head says he uses needlenose pliers in place of the 4493.  Don't
know how he gets enough leverage.


At 11:22 PM 10/6/2005 -0600, John Dodd wrote:
>First, thanks for all the support that I got up to now.
>I couldn't have got this far without it.
>I gave my V8 last rights so I'm ready for the belt.
> 
>1.       Looking at the water pump, one bolt is obstructed by a piece
>(cannot name it) that holds the Idle Stabil. Valve and some other stuff
>with electrical connectors.
>How do I remove that screw? 
> 
>2.       On pag 15-30-6 it says to insert setting tool 3204 below
>mounting bolt .Also referenced on pag 15-35-2.
>IS it needed?
> 
>3.    O pag 15-35-2 says to turn idler pulley eccentric using tool US
>4493.  I do not have that either.
> 
> 
>3.       Hall sensor. Mine is dirty so I can't figure out how to (or
>where ) to pull on it ?I hear they break a lot.
>Only the connector comes off ? Seems to have a small rubber boot on it.
> 
> 
>John
>_______________________________________________
>Audifans V8 mailing list
>Send posts to: mailto:V8 at audifans.com
>Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
>Have an Audi V8 question?  Check the Audifans Knowledgebase!
>http://www.audifans.com/twiki/bin/view/Audi/V8
>Have a V8 answer? ... Please help others by adding to the KB ... all 
>contributions welcome!