[V8] distributors mounting

[cobram@juno.com]

DO NOT force them in.  The distributors are indexed to the cam, they only
go in one way, DO NOT use longer bolts to force them in, if you line up
the slot and you think the resistance is from the new orings, lube them a
little with oil or silicone.  Since they only go in one way, you would
really have to try to put them in 180 out.  Feel around as you push them
in to make sure the seals are centered, if they're not and you force it
they could tear.  Steady pressure.

BCNU,
http://www.geocities.com/cobramsri/
Look at it this way: in a hundred years, who's gonna care?

John Dodd <jidodd at shaw.ca> writes:
> Hi guys
> I'm trying to set in place the 2 distributors ,part of the TB job.
> I cannot push them in since I put  new rings and they are very 
> tight.
>  
> 1.        Does the rotor orientation matter or do I have to line it 
> with
> the slot in the distributor ?
> 2.        Could the rotor go in 180 degrees off ?
> 3.        How do you push them in ? I noticed the distributor body 
> has 2
> slots on the outside .I think the smaller one goes over the pin.
>  
>  I plan on buying 2 bolts slightly longer than the originals and 
> tighten
> them so they pull the distributor in. Any other ideas ?
>  
> Thanks guys
> Almost there ! 
> John