[V8] Combo Switch "Headlight/Turn Signal"

[Greg Furstenwerth]

My biggest fear is that the airbag will go PFFFT!! and explode in my
face :/

Kneale Brownson wrote:
> You have to remove the steering wheel, which means first removing the
> airbag.  Take the two Phillips head screws out of the top cover to the
> switch trim (from below),  take out the two Torx screws from the back of
> the steering wheel that hold in the airbag.  Disconnect the wire from the
> airbag to its connector buried behind where the top cover was.  Use big
> socket to undo the steering wheel bolt after you've used a marker pen to
> show the wheel alignment with the steering shaft.  Pull wheel off.  There's
> an angled opening from the console side of the bottom of the switch trim.
> I think it's a Phillips head screw at the end of that opening.  Just loosen
> it some.  Then pull the assembly off the shaft.  Some folks advise
> disconnecting the battery before playing with the airbag.
>
>
>
> At 09:00 PM 9/26/2006 -0700, Greg Furstenwerth wrote:
>   
>> That combo switch I am wanting to replace. Anyone BTDT? I am just
>> wondering what is all involved in the replacement.
>>
>> Kind Regards,
>> Greg Furstenwerth
>> _______________________________________________
>> Audifans V8 mailing list
>> Send posts to: mailto:V8 at audifans.com
>> Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
>> Have an Audi V8 question?  Check the Audifans Knowledgebase!
>> http://www.audifans.com/twiki/bin/view/Audi/V8
>> Have a V8 answer? ... Please help others by adding to the KB ... all 
>> contributions welcome!
>>     
>
> _______________________________________________
> Audifans V8 mailing list
> Send posts to: mailto:V8 at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/v8
> Have an Audi V8 question?  Check the Audifans Knowledgebase!
> http://www.audifans.com/twiki/bin/view/Audi/V8
> Have a V8 answer? ... Please help others by adding to the KB ... all contributions welcome!
>
>