[V8] Starter Question

[cobram at juno.com]

"Ed Kellock" <ekellock at gmail.com> writes:

> I did the R&R myself and it took far longer than one hour, until I
> knew where the magic bolt was and how to get it out.  Not sure I'm 

I cut a 20mm long piece off a 10mm Allen wrench, then put it the starter
bolt with a 10mm gear wrench over the allen.  Bolt went in an out very
easily this way.  IIRC I may have used a large screw driver to guarantee
that the allen was well seated in the starter bolt.  

The cut allen sits in the specialty tool section of my toolbox, as long
as I have it, I will never need it again.  Just like those parts that sit
around for decades, you'll only need them after you give them away or
toss them.

 
BCNU,
http://www.geocities.com/cobramsri/
Hit any key to continue, or any other key to quit.