[V8] Bearing puller

[Tony and Lillie]

The hub is inside of the bearing, pressed into it. So, you have to pull the 
hub from the bearing first, and usually the outer race comes off with it. 
Then, You can pull the holding clips and th e bearing itself. They, you 
remove the old race from the hub, put the new bearing in, and then th e hub 
goes back in.

Sounds simple, huh ;-)
Tony
----- Original Message ----- 
Subject: Re: [V8] Bearing puller
>
> Not having done this before (or yet), but having thought about it a lot
> (having a few done at the local wrenches, $$), I'm aware of the HF puller.
> But, what do you mean "pulling the hub itself from the bearing"?  I 
> thought
> (hoped) the hub stayed on the car.