[V8] Audi tool 2084

[Tony and Lillie]

That's exactly what I was about to suggest. The engine turns clockwise as 
you look at it from teh front, IIRC. The bolt is 27mm. I built a tool to 
hold it out of flat steel and a 2 1/2" pipe or so. Welded together, and cut 
the notches mentioned. It works on both the V8 and the 5-cyl's.

Tony

----- Original Message ----- 
Subject: Re: [V8] Audi tool 2084


> Use the torque of your starter motor. A socket/ratchet & long pipe 
> extension
> works well when you briefly activate the starter. The V8 is 28mm, not sure
> what the 4k is. I normally rest the pipe on one of the frame arms or 
> ground.
> Sounds scary, is scary, but works every time you don't have a tool or
> impact.
>
> It is important to note the timing belt should be intact or briefly
> reinstalled if you try this procedure.
>
> Samuel
>