[V8] Need the passenger-side distributor for '91 3.6

[toml99 at todomundo.com]

Hey Kevin, I"m staring @ my only spare intact distributor, and like I  
said, I'm pretty sure that plastic plate does nothing more than hold  
the wires down.  It's got an intact/newer rotor glued on, so I can't  
verify removal of that window "can"....As I recall, I soldered the 3  
wires on Pearl with all that intact since it seemed you needed to  
push out the whole shaft from below(remove spring thing, and push out  
pin to remove cam locater).   Honestly, if it were me, I'd pry out  
loose plastic and see if it moves freely, and just go with it as long  
as Hall is still attached to steel plate and functioning.  Otherwise,  
I'd push out shaft from below after removing that pin/cam locator and  
while in there, probably replace that hall sender.....This is  
something that everyone will have to do @ some point in the future,  
so?  I'm pretty sure I stole the dizzy from parts car for the Black  
car that's now in my friend's son's hands......so, I've got no  
scrapper to mess with, otherwise, I's pull it apart tomorrow.  I've  
got 1 good low mileage spare, and 2 cars that  need it....so can't  
part with it.  Good luck, Tom