[Vwdiesel] cvjoints yet again...
LBaird119 at aol.com
LBaird119 at aol.com
Fri Nov 1 01:22:09 EST 2002
> So I tried to change the cv's from the 82 Jetta trans to the 94 Jetta
> trans... They are not interchangeable. Blast. Seal surfaces are waaaay
> different diameters, so the next option is to change joints. Now the
> hundred dollar question is do the 100mm joints fit on a little axle shaft
> from the 90mm joint- that is to say, is the inner spline the same? I don't
> have the axle with big joints to compare, so I have to buy these to find
> out. Etka doesn't have specs either, so that isn't much help. Thanks lots.
Sure it does but in a different fashion. :) Somewhere in the mid to
latter
80's they went to the 100mm flange. The thing to check then is the shaft
it goes on. They use the same 020-409-291 B shaft on the earlier, 90mm
flanged transmissions as they do up to 90. In 90 they stop listing the part
number for the shaft but the design is the same so it's highly likely the
shaft didn't change. In 94 though they show the shaft and flange as a
single unit. This would create a problem! It looks like as long as you
have a tranny with separate flange and drive shaft, you can go either
way. It just depends on which flange you put on. :)
Loren
More information about the Vwdiesel
mailing list