[Vwdiesel] rev issues

[Nate Wall]

<<<
Can this screw be played with safely? (ie.. can I get it back to where
it was easily if I decide to muck with it).>>>

This is what I did (to remove the anti-tamper sleeve spot welded on that screw):

1. Place a paper towel under the screw area (all the fuel in the pump willl
drain).
2. Undo the lock nut on the screw.
3. Remove the screw. Note the orientation of the screw's slot. CAREFULLY COUNT
the turns required to remove it. WRITE THIS INFO DOWN!
4. Place the screw in a vice, noting it has an "O" ring on it. Don't damage the
"O" ring.
5. Chisel off the stainless steel spot welted anti-tamper sleeve. I used a sharp
wood chisel.
6. Re-install the screw, the exact same number of turns, stoping at the correct
slot orientation.
7. Snug the nut.
8. Try adjustments in 1/8 turn increments. In = more fuel. Get to a "smoke
comfort level" and power level you like.

--Nate