[Vwdiesel] Peetering Pressure pumps performance

[gary]

In retrospect,
Yes, you could run a wire through the head from the oil sensor hole.

You could also pull the cam(leave the head) and run a wire through #4
bearing hole that runs straight into the head bolt hole (#3 per the
torquing sequence) that feeds the head circuit.

The only way to run a wire down into the block would be to pull the
head. You can't get to that circuit any other way.


-Gary


On Sun, 2004-08-29 at 20:00, Mark Shepherd wrote:

> Looking at my gasser circuit diagrams oilpressure
> sensors are 1.8bar and 0.3bar for the head.
> Specification limit is 2 bar 29lb @2000rpm.
> Can the oil way be rodded from underneath with oil
> pump off?
> What about the oil channel behind the head sensor?
> The Miser
> 
> _______________________________________________
> Vwdiesel mailing list
> Vwdiesel at vwfans.com
> http://www.audifans.com/mailman/listinfo/vwdiesel