[Vwdiesel] IP removal question

James Hansen jhsg at sasktel.net
Fri May 20 02:08:20 EDT 2005


I usualy need to get a puller on it and then hit the puller when it's
screaming tight. Coupla hits and it pops off.  Only one that fits is a small
two jaw that lets you grab the inner hub rather than trying to grab the
outer pulley and screwing that up.  I'm always afraid of damaging threads
when I loosen a nut then hammer on it. DOne ithat more than once...
-J

-----Original Message-----
From: vwdiesel-bounces at vwfans.com [mailto:vwdiesel-bounces at vwfans.com]On
Behalf Of LBaird119 at aol.com
Sent: Thursday, May 19, 2005 11:22 PM
To: vwdiesel at audifans.com
Subject: Re: [Vwdiesel] IP removal question


  Pretty much as Chuck said.
Often I just loosen the nut to flush and give it a whap with a heavy
hammer.  There's not much room to swing so more "m" than "v"
helps.  If it's stubborn then I wedge tightly, 180 apart and whap
again.  Usually about 3 whaps does it.  Works well on stubborn
cams too
     Loren
_______________________________________________
Vwdiesel mailing list
Vwdiesel at vwfans.com
http://www.audifans.com/mailman/listinfo/vwdiesel
--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.12 - Release Date: 5/17/2005

--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.11.12 - Release Date: 5/17/2005



More information about the Vwdiesel mailing list