[Vwdiesel] Quattro no start

[Tony and Lillie]

The 4000 Quattro's do not have this. The turbo cars have an integral 
ignition and fuel injection control, required to run them correctly. The 
4000's have a completely seperate control for the ignition, and therefore 
only the hall sender and the ignition control are required in addition to 
the normal components for spark. Fot the fuel pump to run, the relay has to 
see signal from the hall sender.

Tony Hoffman

----- Original Message ----- 
From: "82 Diesel Westy" <dieselwesty at yahoo.com>
To: <MWoodland at Dentsply.com>; <vwdiesel at vwfans.com>
Cc: <LBaird119 at aol.com>
Sent: Tuesday, August 08, 2006 5:34 AM
Subject: Re: [Vwdiesel] Quattro no start


>I have a 90 Audi 200 that works that way, fuel pump
> will not turn on until a sensor sees enough RPM on
> flywheel.  I do not think an 84 VW Quattro was wired
> that way, but if it has the slot for the fuse in top
> of relay (my relay is stamped 215) then it most likely
> is not running.  Put a 10amp fuse in, go to pre-start
> on key for 10 seconds.  key off, remove fuse, try to
> start again.
>
> Bryan
>