[Vwdiesel] final drive seals
mikitka
mikitka at earthlink.net
Sun Jan 22 15:17:08 EST 2006
I did mine while still in the car. No problem at all. Once you get the "C"
clip off the flange comes off and you just pull off the old seals and put
the new ones on. I made a tool using a long 5" bolt that threaded into the
tranny stub shaft and a 1 inch wide by I think 5 inch long flat stock.
Worked great.
Nick
-----Original Message-----
From: vwdiesel-bounces at vwfans.com [mailto:vwdiesel-bounces at vwfans.com] On
Behalf Of Pam & Doug Boes
Sent: Sunday, January 22, 2006 12:28 PM
To: vwdiesel at vwfans.com
Subject: [Vwdiesel] final drive seals
I'm planning to do a trans swap. I will replace the main shaft seal, the
pushrod seal and the engine rear main seal as well as the clutch. I'd also
like to replace the seals on the final drive. How difficult is removal of
the drive flanges to get access to the seals. Are there any special tools
required for flange removal or seal installation?
_______________________________________________
Vwdiesel mailing list
Vwdiesel at vwfans.com
http://www.audifans.com/mailman/listinfo/vwdiesel
More information about the Vwdiesel
mailing list