[Vwdiesel] 1.6 mm head stud kit
Andrew .Libby
libbybapa at gmail.com
Fri Jul 30 11:23:19 PDT 2010
There weren't any VW TD engines with 11mm studs.
The difference with the newly released TDI/IDI stud kit is added tensile
strength to accommodate additional torque for proper sealing of the head
gasket when using the later multi-layer-steel gaskets which require more
clamping force to seal well. If using the older 1.6 fiber gasket, the
Cosworth studs work very well. I have also quite successfully used the
Cosworth studs with the later MLS gaskets and torqued to 90+ ft. lbs.
Andrew
On Fri, Jul 30, 2010 at 5:18 AM, Patrick Dolan <pmdolan at sasktel.net> wrote:
> Thanks for that (I read the last post before this one). I imagine the VW
> gasser studs should work quite well for TD application. As I said before,
> though, ARP stud kits are very specific to each engine (it is more than a
> dimensional thing) - as is the toque required to achieve the required gasket
> clamping force without cylinder head distortion. Before using the gasser
> studs, I would recommend a call to ARP tech services.
>
> ----- Original Message -----
> From: "Andrew .Libby" <libbybapa at gmail.com>
> Date: Friday, July 30, 2010 1:37 am
> Subject: Re: [Vwdiesel] 1.6 mm head stud kit
>
> > The 11mm studs are the same as the gasser studs. Part # is *204-
> > 4701. *That
> > said, I wouldn't personally invest any labor or expense in any
> > 11mm block.
> >
> > Andrew
> >
> > On Fri, Jul 30, 2010 at 12:42 AM, William J Toensing
> > <toensing at wildblue.net>wrote:
> >
> > > I don't recall any 11 mm head studs but 12 mm ARP studs are
> > available from
> > > Summit Racing supply & I think they are the cheapest source. I
> > believe they
> > > are listed for a British Ford Cortina Coxworth, If I recall
> > correctly. On my
> > > 1981 Dasher diesel I had to re-tap the block bolt holes to 12
> > mm. In doing
> > > this you have to be real careful to have your 12 mm tap
> > perpendicular to the
> > > deck or top of the block. If someone has some suggestions on how
> > to do this
> > > or some jig or tool that is available to do this please let us know.
> > > Bill Toensing, Nevada City, CA
> > > _______________________________________________
> > > Vwdiesel mailing list
> > > Vwdiesel at vwfans.com
> > > http://www.audifans.com/mailman/listinfo/vwdiesel
> > >
> > _______________________________________________
> > Vwdiesel mailing list
> > Vwdiesel at vwfans.com
> > http://www.audifans.com/mailman/listinfo/vwdiesel
> >
>
>
More information about the Vwdiesel
mailing list