[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]
Re: 4k wheel bearings...
In a message dated 95-11-12 17:26:32 EST, you write:
>Anyone have a better idea?
There is a tool especially for this. It looks like two crescent moons facing
each other with bolts at either end to tighten the moons around the hub,
under the race. Then you just press the hub out.
Just a tip.........When pressing the hub into the new bearing, be sure and
support the inner race from the back side or you chance shortening the life
of or ruining the bearing.
-----peter
Audionly