Re: Head Work

["Bob D'Amato" <Bob.Damato@snetel.com>]

On Fri, 22 Mar 1996 PDQSHIP@aol.com wrote:

> 
> Agree here.  Large valves on a turbo motor that are cut correctly, should not
> cost any low end performance vs the stock setup.....  Few people just add
> valves, the fact is a proper head modification will give the whole rpm range
> an increase over stock......
> 

Big valves=lower redline. There is a lot of mass to move in a big valves. 
Four smaller valves are not only lighter, but breathe better than bib valves.
BTDT

Bob


    ______       
___/   __ \______    ___       __     ___  ___              __   
        _\_\_____)  / _ )___  / /    / _ \/ _ | __ _  ___ _/ /____
       (____)      / _  / _ \/ _ \  / // / __ |/  ' \/ _ `/ __/ _ \
__    (_____)     /____/\___/_.__/ /____/_/ |_/_/_/_/\_,_/\__/\___/
  \____(___)   bob.damato@snetel.com   http://snetel.com/audi/audi.html
                                                 
The Southern New England Telephone Co.	     |Phone: 203-771-7081
Information and Technology Center            |Fax:   203-773-3398
300 George St. New Haven CT  06510           |Pager: Dont count on it

                   Drive Safe, Drive Fast, Drive a Quattro