Bose speaker impedances

[Brooks Ellis <brooks@fortnet.org>]

If you are worried that they are too low, maybe 2 or 3 ohms; just go get a
20watt 1ohm power resistor. I think I bought two for a dollar some place.
I'm sure radio shack would have them. A two ohm power resistor would make
DAMN sure you were in the safe zone. 

Peace and good vibrations,
brooks

( My next project is to get some passive crossovers to drive the rears and a
sub off of one amp in mixed mono mode.. Then I will put probably 10 or 12
ohm resistors on the rears, because I seriously dislike a lot of rear fill )