re: O2 wrench size info needed...

["A. D. Morris" <allanm@primenet.com>]

> Date:          Sun, 2 Jun 1996 22:47:38 -0400
> To:            allanm@primenet.com
> From:          Robert Myers <rmyers@wvit.wvnet.edu>
> Subject:       re:  O2 wrench size info needed...
> Cc:            "Quattro list" <quattro@coimbra.ans.net>

> FYI, Y'all,
> 
> While skimming a recent JCWhitney catalog, I saw a special socket designed
> for just this purpose.  It is a deep socket with a fairly wide slot up the
> side through which the wires fit.  It is listed as a 7/8 inch socket size.
> The caption indicated that all O2 sensors require the same size socket.  7/8
> inch calculates out to 22.225 mm.  Probably close enough.  The price for the
> socket was about $6 to $7 as I remember.
> 
<<<<Snip>>>>>>>>

Most auto parts stores here have the socket - but some of them are 
kind of cheap, and may not hold up well to stress YMMV.  
My O2 sensor, came out very easily :), so stress was not a problem 
for a borrowed  22 mm box end wrench.

>
> ___
>    Bob
> ****************************************************
> *  Robert L. Myers         rmyers@wvit.wvnet.edu>  *
> *  Rt. 1, Box 57            304-574-2372           *
> *  Fayetteville, WV 25840                          *
> ****************************************************
> 
> 

-----------------------------------
A. D. Morris
Phoenix, AZ
allanm@primenet.com
1988 90Q
-----------------------------------