Re: 4000 timing

[bat@tcnet.net]

AUDIDUDI@delphi.com wrote:
> 
> > when the other marks are in line then the dot should be in a position
> > about even with the cam cover gasket.
> 
> I'm not so sure ... I noticed that when I was replacing the timing belt on
> my 200q that I could get the flywheel and crank pulley marks to line up at
> TDC but not the cam sprocket as well.  It ended up too high or too low ...
> since I was installing an adjustable sprocket and really wanted to be sure
> it was set at TDC to start with, I dug out my dial indicators and lined up
> both the camshaft lobes and No. 1 piston.  Guess what?  The dimple was off
> by a bit more than one-half of a tooth (aka +/- 4 degrees)!  Could this be
> considered a normal production line tolerance or was it just a fluke on my
> car?  Either way, it's given me pause to wonder about how tightly Audi has
> spec'd some of the OTHER tolerances...
> 
>      _             _
>     / l       l o l  \       l o   Jeffrey Goggin
>    /__l l l / l l l  l l l / l l   * * * * * * *
>   /   l l_l \_l l l__/ l_l \_l l   AudiDudi@delphi.com
> GET ME OFF THIS SERVICE !!!!!!!