Re: Curriculum Vitaes

[PDQSHIP@aol.com]

In a message dated 96-06-24 12:27:45 EDT, you write:

<< I found it impossible to do  while the drive shaft was on the
 	car.  I took it off and took it to a mechanic. He put it in
 	a big vise, held the the circlip open with a pair of needlenose
 	pliers (I think he had some means of locking them) and hammered
 	the CV joint off. Took him less than ten minutes.
  >>
Bingo, doubt you'll be able to do it with the driveshaft on, esp since you
are in salt land....  Get the 10MM triple square and get it off the car
first, then rastle with it.....  Don't forget there is a rubber seal that you
will need to replace between the driveshaft and trans...

Scott