Re: Clutch Bleeding - 89 200 TBQ

["Graydon D. Stuckey" <graydon@apollo.gmi.edu>]

On Fri, 6 Sep 1996, Chris Lemon wrote:

> There is a way to construct a pressure bleeder with a spare cap, a schrader
> valve, and a compressed air tank.  Just be sure you don't put too much air
> into the reservoir; I think 20-25 PSI should probably be the max...
> 

I installed an air nipple on a spare cap, and hooked up the shop air 
line, regulated down to about 3-5 psi.  Any more than that and the cap 
popped off.  You just have to watch that you donm't run out of fluid.

Later, ---------------------------------------------------------- 
Graydon D. Stuckey 	'85 Mazda RX7 GS, no toys 
graydon@apollo.gmi.edu 	'86 Audi 5000 CS Turbo Quattro, has toys
Flint, Michigan USA	'89 Thunderbird SC, lotsa toys