[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re:4kq Turbo install....

To: mike tipton <mtipton@netten.net>
Subject: Re:4kq Turbo install....
From: John Karasaki <johkar@teleport.com>
Date: Wed, 25 Sep 1996 23:48:02 -0700 (PDT)
Cc: quattro@coimbra.ans.net
Sender: owner-quattro@coimbra.ans.net

At 07:16 PM 9/25/96 -0500, you wrote:
>To install the turbo "correctly" in the non turbo OEM 4kq, you will 
>basically need the entire engine, ECU, electrical harness,fuel injection
>system, and turbo plumbing.
>
>This is what "is needed" to make the "swap" survive and pass emmision!
>
You also need the passenger side tie rod (?) from a TQC if you plan on using
the stock wastegate.  Probably the hardest piece to come by.
Regards,

John Karasaki

Quattro Club (regional & national) member

Prev by Author: Re: Upgrading 100Q to Euro Lights
Next by Author: Re: 4KQ stress bar- SPARCO source?
Prev by thread: Re:4kq Turbo install....
Next by thread: Re: Fiberglass Rear Trunk lid
Index(es):
- Author
- Thread